[Elecraft] Firmware

[Mike Harris]

Quite so.

However, this sounds like a pretty old K3 that hasn't been blessed with 
certain or any factory hardware mods which will have a bearing on 
features available and detailed in the revised menu options.

At the very least the firmware release notes, which are presented in 
historical detail with each firmware release, need to be read through.

Regards and good luck,

Mike VP8NO

On 14/06/2020 12:27, Don Wilhelm wrote:
> Joe,
> 
> I cannot recall any instance where the firmware upgrade broke the K3 - 
> same for the KX3/KX2.
> There have been a few who suspected a problem with a firmware upgrade, 
> but it turned out to be some other problem.
> 
> I would recommend that you simply upgrade to the latest and be done with 
> it.
> 
> 73,
> Don W3FPR
> 
> On 6/14/2020 9:28 AM, Joseph McIntire wrote:
>> Hello all,
>>     I was looking for some older  firmware for the K3. I found  the  
>> latest  on Elecraft's web site. But my radio currently has MCU1.96 and 
>> SYN 1.73. I didn't want to jump straight to the latest  version  due 
>> to if o e of the  versions affected  my  radio  adversely I would not 
>> know which one caused it. So I was wanting to find each individual  
>> version so I could load them as I want.i may want to stop  before I 
>> get to the latest version. Thank you for listening to my rambling.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to mike.harris at horizon.co.fk