[Elecraft] K3S in QRP mode

[Alan - G4GNX]

The setting for the PA module is probably re-set to NOT INSTALLED.

73,

Alan. G4GNX


------ Original Message ------
From: "Bill DeVore" <maxrcul at gmail.com>
To: elecraft at mailman.qth.net
Sent: 26/07/2020 20:39:51
Subject: [Elecraft] K3S in QRP mode

>I recently did a Parameter Initialization on my K3S. I didn’t save the current firmware configuration as I’ve never done any custom programming on the radio.
>
>After performing the initialization, a full rotation of the Power knob only goes from 0 to a maximum of 12 w on any band. Prior to the initialization of the rig, I could adjust power all the way to a max of 110w on each band.
>
>Did the initialization set the rig in QRP mode? I sure hope there’s a configuration menu somewhere that I can change to get the radio back to full power.
>
>Bill - W3PNM
>______________________________________________________________
>Elecraft mailing list
>Home: http://mailman.qth.net/mailman/listinfo/elecraft
>Help: http://mailman.qth.net/mmfaq.htm
>Post: mailto:Elecraft at mailman.qth.net
>
>This list hosted by: http://www.qsl.net
>Please help support this email list: http://www.qsl.net/donate.html
>Message delivered to g4gnx at g4gnx.com