[Elecraft] P3 SVGA board blinking red light

[Michael Gillen]

OK thank you.


> On Jul 25, 2020, at 9:56 AM, Grant Youngman <ghyoungman at gmail.com> wrote:
> 
> The blinking red light is normal.  Indicates the onboard processor is working.
> 
> Grant NQ5T
> 
>> On Jul 25, 2020, at 12:48 PM, Michael Gillen via Elecraft <elecraft at mailman.qth.net> wrote:
>> 
>> My P3SVGA board is acting up and there is a blinking red light on the board (did not notice that before because the lid was always on).
>> 
>> Is the blinking red light bad? If yes, is there something I can do about it?
>> 
>> My symptoms are that I am unable to successfully load the FPGAx firmware - it fails for all FPGA’s with “block 657 write failed”.
>> 
>> 
>> Thanks guys!
>> Michael
>> KK6RWK
>> 
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>> 
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>> Message delivered to ghyoungman at gmail.com
>