[Elecraft] P3 SVGA board blinking red light

[Grant Youngman]

The blinking red light is normal.  Indicates the onboard processor is working.

Grant NQ5T

> On Jul 25, 2020, at 12:48 PM, Michael Gillen via Elecraft <elecraft at mailman.qth.net> wrote:
> 
> My P3SVGA board is acting up and there is a blinking red light on the board (did not notice that before because the lid was always on).
> 
> Is the blinking red light bad? If yes, is there something I can do about it?
> 
> My symptoms are that I am unable to successfully load the FPGAx firmware - it fails for all FPGA’s with “block 657 write failed”.
> 
> 
> Thanks guys!
> Michael
> KK6RWK
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to ghyoungman at gmail.com