[Elecraft] Can't Hear My Sending CW on K3S

[Dave Cole]

Put the K3 in CW mode, then press and hold the CMP/PWR/MON knob, the 
display will change to MON, that is your sidetone adjustment.

73, and thanks,
Dave (NK7Z)
https://www.nk7z.net
ARRL Volunteer Examiner
ARRL Technical Specialist
ARRL Asst. Director, NW Division, Technical Resources

On 7/16/20 10:16 AM, Nr4c wrote:
> You probably have the TX Monitor set to zero. Press and hold for 3 sec the Comp/Pwr knob. VFO B display will change to TX MON and show setting. Adjust as needed (2-5 should be in ballpark).
> 
> Sent from my iPhone
> ...nr4c. bill
> 
> 
>> On Jul 16, 2020, at 1:05 PM, John Stengrevics <jstengrevics at comcast.net> wrote:
>>
>> When I send CW on my K3S, I cannot hear it either on the speaker or phones.  As most probably are, I am dependent on the auditory feedback to send CW properly.
>>
>> I suspect I have a setting wrong.
>>
>> Any advice would be much appreciated.
>>
>> 73,
>>
>> John
>> WA1EAZ
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>>
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>> Message delivered to nr4c at widomaker.com
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to dave at nk7z.net
>