[Elecraft] K-POD working intermitterly

[Clay Autery]

My apologies....  I said it was RJ-12....  I believe I remembered 
incorrectly....  It's an RJ-25 (straight thru).  RJ-12 is a handset 
cable with NON-straight thru wiring... essentially reversed to bridge 
the handset to the base device.
RJ-25 is a 3-line, straight thru cable.  <blush>  That'll teach me to 
respond from an obviously faulty memory.

______________________
Clay Autery, KY5G
(318) 518-1389

On 01/13/20 16:00, John Altman wrote:
>   My K-Pod has stopped working ... it works (macros are functional) for a
> few minutes after K3S turned on and then power light is out and button
> functions do not work!  Turn rig off and back on a few minutes later and it
> functions, for awhile.
>
> I have reloaded full firmware for both K3S and P3 ... no behavioral change.
>
> I have disconnected K-Pod cable at both rig and K-Pod, re-connect, no
> change.
> Cable is connected in jack under front panel.
>
> Otherwise, K3S is fully functional.  I am aware the “macros” reside within
> the K3S.
> Could this be the cable between the rig and K-POD?
>
> Any ideas to remedy this situation will be greatly appreciated.  Direct
> reply to WA4AIP at ARRL.NET.
>
> Thank you,
> John  WA4AIP
> K-LINE Station
> ARRL Charter Life Member
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to ky5g at montac.com