[Elecraft] K-POD working intermitterly

Clay Autery KY5G at montac.com
Tue Jan 14 04:23:03 EST 2020


MY bet is a bad KPOD cable....  As I remember it, it is a straight 
through cable with 6P6C, RJ12 connectors on both ends.
You could make one if you have CAT-5e cable, 6P6C connectors, and a 
crimp tool.
You simply use 3 of the 4-pairs...  Cut 4th pair back to jacket (brown 
has the loosest twist rate, I'd pick that one).

And whatever pair you use for Pins 1/2, simply cut the wire that WOULD 
be on Pin 1 back to the jacket at the radio at least, and I would cut it 
back on both ends to "be sure" AND not have a "stub" sticking out in space.
Crimp them, preferably with connector boot on the KPOD end.  IF you have 
your radio elevated on the from side, there is room for a boot on the 
radio end as well.

If you have the radio sitting flat, there MAY not be room for a 
boot....  6P6C/RJ12 connector boots may be hard to find.
In the case that you DON'T use boots, it is IMPORTANT to make SURE that 
the jacket gets crimped under the connector's strain relief bar on crimp 
to keep the conductors from separating due to work hardening of the 
copper when moving the cable.

AND, as always for PATCH CABLES, use stranded cable and connectors 
spec'd for stranded cable to be safe.  You CAN use solid cable or solid 
wire connectors, but the durability will be greatly reduced.

Hope this helps...

73,

______________________
Clay Autery, KY5G
(318) 518-1389

On 01/13/20 16:00, John Altman wrote:
>   My K-Pod has stopped working ... it works (macros are functional) for a
> few minutes after K3S turned on and then power light is out and button
> functions do not work!  Turn rig off and back on a few minutes later and it
> functions, for awhile.
>
> I have reloaded full firmware for both K3S and P3 ... no behavioral change.
>
> I have disconnected K-Pod cable at both rig and K-Pod, re-connect, no
> change.
> Cable is connected in jack under front panel.
>
> Otherwise, K3S is fully functional.  I am aware the “macros” reside within
> the K3S.
> Could this be the cable between the rig and K-POD?
>
> Any ideas to remedy this situation will be greatly appreciated.  Direct
> reply to WA4AIP at ARRL.NET.
>
> Thank you,
> John  WA4AIP
> K-LINE Station
> ARRL Charter Life Member


More information about the Elecraft mailing list