[Elecraft] Connecting K3/0 to K3S

[Don Wilhelm]

Sorry for the finger slip - thanks Ed - the baud rate is 38400.  You 
will not find 28400 listed, so it should be obvious.

73,
Don W3FPR

-----------------------------------------------------------------------------------
There is an RS-232 "dongle" that ships with every K3S. It has an RJ-45 
plug on one end and an RS-232 DE9 connector on the other end.
If you plug it in, change the switch on the KIO3B board (inside the K3S) 
to RS-232 and change the RS232 menu entry to 28400 baud, you can use 
that connection just like on the K3 - note that you will also use that 
same connection for firmware downloads and other K3 Utility operations 
(i.e. the USB connection will not be usable).

73,
Don W3FPR

On 2/17/2020 6:05 PM, W4IEN wrote:
> I have a problem that I am sure some of you have run into. I am trying 
> to use my K3S remotely using a K3/0 with the RemoteRig 1258 MKIIs 
> hardware. I can get everything set up except for the connection from 
> the RS232 to the RS232 on the RemoteRig hardware. The RS232 on the K3S 
> does not have the same type of connector as the RemoteRig hardware. 
> Has anyone gotten around this problem. Any help would be appreciated. 
> Hope I explained my situation well enough so it is understandable.