[Elecraft] TCP Port for KPA500 and KAT500

[Jack Brindle]

There must be an interface box in between the network and the KPA500 and KAT500, since neither support network communications, only serial.

You might want to describe what you are doing and what devices you are using.

73!
Jack, W6FB


> On Feb 17, 2020, at 11:37 AM, VO1HPFrank <invl160 at gmail.com> wrote:
> 
> This may be a dumb question but here goes....
> 
> In the Elecraft remote software for the KPA500 and the KAT500 the TCP port
> for the KPA500  is 4626 and 4627 for the KAT500.  Are these ports somehow 
> "hard coded"  in the communications software for the two units?...OR can one
> assign any port.  
> 
> I am thinking about the port forwarding that must be done in my remote
> router as I am working on the installation of an Ethernet to Serial Port
> server at my remote site.  Should I use the elecraft  port number in the
> remote router to direct packets from the control end to the IP of the Port
> Server at the remote to which the amp is connected....and vice versa to
> establish the return path from the amp  to the router and control software 
> at the Control end.
> 
> I hope someone can understand this better then the way I have described it.
> 
> Frank VO1HP
> 
> 
> 
> 
> 
> --
> Sent from: http://elecraft.365791.n2.nabble.com/
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to jackbrindle at me.com