[Elecraft] TCP Port for KPA500 and KAT500

[VO1HPFrank]

This may be a dumb question but here goes....

In the Elecraft remote software for the KPA500 and the KAT500 the TCP port
for the KPA500  is 4626 and 4627 for the KAT500.  Are these ports somehow 
"hard coded"  in the communications software for the two units?...OR can one
assign any port.  

I am thinking about the port forwarding that must be done in my remote
router as I am working on the installation of an Ethernet to Serial Port
server at my remote site.  Should I use the elecraft  port number in the
remote router to direct packets from the control end to the IP of the Port
Server at the remote to which the amp is connected....and vice versa to
establish the return path from the amp  to the router and control software 
at the Control end.

I hope someone can understand this better then the way I have described it.

Frank VO1HP





--
Sent from: http://elecraft.365791.n2.nabble.com/