[Elecraft] Interfacing K2 to KPA1500?

[Ken K6MR]

Yes.

Ken K6MR

From: eric norris via Elecraft<mailto:elecraft at mailman.qth.net>
Sent: Saturday, December 12, 2020 11:28
To: donwilh at embarqmail.com<mailto:donwilh at embarqmail.com>; Don Wilhelm<mailto:donwilh at embarqmail.com>; Elecraft Reflector<mailto:elecraft at mailman.qth.net>; N6TV Bob Wilson<mailto:n6tv at arrl.net>
Subject: Re: [Elecraft] Interfacing K2 to KPA1500?

Don, et al,
Can I assume the same is true of a K2/10 with the AUX IO option?  Are they wired the same?

73, Eric WD6DBM



  On Sat, Dec 12, 2020 at 9:47 AM, Don Wilhelm<donwilh at embarqmail.com> wrote:   Eric,

The KPA100 RS-232 data appears on pins 2 and 3 of the AUX IO connector
with pin 5 being RS-232 Signal Ground.  Chassis ground is on pin 1. See
the KPA100 manual.
DO NOT connect to any other pins of the AUX IO connector, those are
internal K2 signals to be used by external devices such as the KAT100 or
XV series transverters.

I can't help with the KPA1500 end.

73,
Don W3FPR

On 12/12/2020 8:05 AM, eric norris via Elecraft wrote:
> The KPA1500 Manual mentions using a K2 with serial interface for band data, but does not show how to wire it (that I can find).  I can't find it in the nabble archive either.  Does anyone know how to do this?
> Thanks and
>
> 73, Eric WD6DBM

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to k6mr at outlook.com