[Elecraft] Frequency display on P3?

[Clay Autery]

+1, yup!  Mine is spot on, as calibrated... as in less than 1 Hz error rate.

______________________
Clay Autery, KY5G
(318) 518-1389

On 04/24/20 20:27, M. George wrote:
> It sounds like you need to do the frequency calibration as documented on
> page 39 of the manual
> <https://ftp.elecraft.com/P3/Manuals%20Downloads/E740152%20P3%20Owner's%20man%20Rev%20H1.pdf>
> :
> https://ftp.elecraft.com/P3/Manuals%20Downloads/E740152%20P3%20Owner's%20man%20Rev%20H1.pdf
>
> Max NG7M
>
>
> On Fri, Apr 24, 2020 at 7:14 PM Frank O'Donnell <vfo77 at inkbox.net> wrote:
>
>> Here's what I'm sure is a beginner question.
>>
>> If I feed an accurate signal from a waveform generator into my K3S, on
>> the P3 it appears right about 120 Hz higher than the actual frequency.
>> This seems to be independent of the mode the K3S is in. What causes that?
>>
>> I noticed this when I had my K3S/P3 running while working the ARRL
>> Frequency Measurement Test with other gear, and was curious about it.
>>
>> Thanks much,
>>
>> Frank K6FOD
>>
>>
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>>
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>> Message delivered to m.matthew.george at gmail.com
>>
>