[Elecraft] Frequency display on P3?

[M. George]

It sounds like you need to do the frequency calibration as documented on
page 39 of the manual
<https://ftp.elecraft.com/P3/Manuals%20Downloads/E740152%20P3%20Owner's%20man%20Rev%20H1.pdf>
:
https://ftp.elecraft.com/P3/Manuals%20Downloads/E740152%20P3%20Owner's%20man%20Rev%20H1.pdf

Max NG7M


On Fri, Apr 24, 2020 at 7:14 PM Frank O'Donnell <vfo77 at inkbox.net> wrote:

> Here's what I'm sure is a beginner question.
>
> If I feed an accurate signal from a waveform generator into my K3S, on
> the P3 it appears right about 120 Hz higher than the actual frequency.
> This seems to be independent of the mode the K3S is in. What causes that?
>
> I noticed this when I had my K3S/P3 running while working the ARRL
> Frequency Measurement Test with other gear, and was curious about it.
>
> Thanks much,
>
> Frank K6FOD
>
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to m.matthew.george at gmail.com
>


-- 
M. George