[Elecraft] setting KPA 100 page 48 problem

[Don Wilhelm]

Christophe,

I made a mistake on the value of C71.  With no K60XV installed, the 
proper value is 82pF (marked either '82' or 820').

73,
Don W3FPR

On 4/11/2020 12:38 PM, Christophe aufacf wrote:
> hello don
>
> I forgot to answer you no K60XV, no rework that I do not know this
> option, I have the NB option provided for purchase
>
> for the parameter D19 = N
>
> thank you in advance
>
> 73 , Cris  F8ACF
>
> Le sam. 11 avr. 2020 à 16:52, Don Wilhelm <donwilh at embarqmail.com> a écrit :
>> Christophe,
>>
>> You have not yet answered 2 important questions which relate to your 40
>> meter operation.
>>
>> 1) Do you have the K60XV option installed (or do you have the Rework
>> Eliminators installed)?
>>
>> 2) What is your setting of the secondary menu D19 parameter?
>>
>> The answers to those 2 questions is critical to what to do next in
>> troubleshooting your problem.
>>
>> 73,
>> Don W3FPR
>>
>> On 4/11/2020 5:24 AM, Christophe aufacf wrote:
>>> hello don
>>>
>>> the frequency to find with CAL FACT 18.159 kHz
>>>
>>> thank you in advance for your good advice
>>>
>>> 73 , Cris F8ACF
>>>
>>> Le ven. 10 avr. 2020 à 21:21, Don Wilhelm <donwilh at embarqmail.com> a écrit :
>>>> Christophe,
>>>>
>>>> Tune the K2 to 7100kHz
>>>> Then plug the internal counter probe into TP1 and the P6 header on the
>>>> Control Board.
>>>> Enter the menu to CAL FCTR and hold EDIT
>>>> The frequency will be seen in the K2 display.
>>>>
>>>> You could alternately use an external frequency counter to read the
>>>> frequency at TP1.
>>>>
>>>> 73,
>>>> Don W3FPR
>>>>
>>>> On 4/10/2020 2:48 PM, Christophe aufacf wrote:
>>>>
>