[Elecraft] 75ohm Impedance question K3S and Antenna side.

[john at kk9a.com]

You can also use coax to make matching transformer however I don't  
know how either of these methods would work for AE4PB's 6 band vertical.

John KK9A




John K9UWA wrote:

Cut the hardline to multiples of 1/2 wavelength and the swr will be 1  
to 1 on both
ends. 50 in 50 out. In this case the OP needs around 200 feet. Once  
your get the
velocity factor for the 1/2" hardline... that is ballpark 80 to 83%.   
for 3.540 mhz is
265 feet x .8 = 212 feet.   If you don't have a piece of test gear to  
get it cut
correctly then put a 50 ohm dummy load at the far end keep cutting until your
wattmeter says 1 to 1 swr. 1/2 wave multiples will hit most of the ham  
bands. A
little high in the 30m band. Close enough.
73
John k9uwa
John Goller, K9UWA & Jean Goller, N9PXF
Antique Radio Restorations
k9uwa at arrl.net
Visit our Web Site at:
http://www.JohnJeanAntiqueRadio.com
4836 Ranch Road
Leo, IN 46765
USA
1-260-637-6426