[Elecraft] VX commands don't work

[Wes]

Works for me too.  Latest F/W installed.

Wes

On 9/22/2019 4:17 PM, David Box wrote:
> VXn works for me, don't remember the firmware change that activated the set feature about a year ago.
> de Dave K5MWR
>
> On September 22, 2019 4:30:54 PM MDT, Don Wilhelm <donwilh at embarqmail.com> wrote:
>> George,
>>
>> The VX command is "GET" only, so you can determine the VOX status, but
>> you cannot SET it.
>> See the K3 Programmer's Reference Manual.
>>
>> 73,
>> Don W3FPR
>>
>> On 9/22/2019 6:16 PM, Kidder, George wrote:
>>> GE all,
>>>
>>> I recently tried to incorporate the VX command into some macros for
>> my
>>> older K3.  With the K3 utility connected directly to Com1, the VXn
>>> command has no effect on the VOX state, although other commands work
>> as
>>> expected.  I run the VOX on AUTO OFF (CW WT tap 5) to avoid startup
>>> problems, but returning to NOR has no effect.  Is this a known bug or
>> a
>>> single-unit flaw.  Any others have this experience?
>>>
>>> I can certainly live without this feature - I have for nearly a
>> decade,
>>> but it would be nice to have it in some macros.
>>>
>>> George, W3HBM
>>> Bar Harbor, ME