[Elecraft] Update on Band Tracking

[Nr4c]

Cables and connectors???

Sent from my iPhone
...nr4c. bill


> On Nov 13, 2019, at 8:41 PM, Jim Danehy <jsdanehy at gmail.com> wrote:
> 
> My K3, upon moving it to a new operating spot now has a tracking issue. I took off the cabling to ease moving to another room. I reinstalled the cabling. However several bands do not switch ON THE KPA 500 when I change bands on the K3. If I hit the key the KPA 500 immediately changed to the band the K3 is on. So RF switching works.
> 
> In the CONFIG Menu I went through the BAND MAP and made sure each BAND was “IN”. But a couple although IN do not follow the K3.
> 
> Any suggestions ? I will update the Firmware since what I have is a few behind. That may cure the problem. In the interim please share your suggestions.
> 
> Thanks
> W9VNE/VA3VNE 
> Sent from my iPhone
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to nr4c at widomaker.com