[Elecraft] Update on Band Tracking

[Jim Danehy]

My K3, upon moving it to a new operating spot now has a tracking issue. I took off the cabling to ease moving to another room. I reinstalled the cabling. However several bands do not switch ON THE KPA 500 when I change bands on the K3. If I hit the key the KPA 500 immediately changed to the band the K3 is on. So RF switching works.

In the CONFIG Menu I went through the BAND MAP and made sure each BAND was “IN”. But a couple although IN do not follow the K3.

Any suggestions ? I will update the Firmware since what I have is a few behind. That may cure the problem. In the interim please share your suggestions.

Thanks
W9VNE/VA3VNE 
Sent from my iPhone