[Elecraft] KX2 waterfall

[Tom]

Hi,
Here is a video on how to set this up with the KX2.  https://youtu.be/fxJq-aQivGk
It will be pretty much the same for the KX2 except that you need the appropriate cable to turn on the switch when you go into transmit.  Also note that there is a newer MFJ switch called the MFJ1708SDR which no longer requires soldering a jumper.
You can use this with an SDRPlay and Win4K3Suite or any software and corresponding SDR.
73 Tom
Va2fsq.com

-----Original Message-----
From: elecraft-bounces at mailman.qth.net <elecraft-bounces at mailman.qth.net> On Behalf Of Don Wilhelm
Sent: May 27, 2019 10:07 AM
To: Adam Goler <adamgoler at gmail.com>; elecraft at mailman.qth.net
Subject: Re: [Elecraft] KX2 waterfall

Adam,

The PX3 uses the RX I/Q output from the KX3.
The KX2 has no RX I/Q output, so it cannot drive the PX3.

Win4K3 does work with the KX2 and it has the capability to provide a panadapter display.  Just how that is done for the KX2 I am not certain, but you may want to check out the Win4K3 webpage.

73,
Don W3FPR

On 5/27/2019 8:58 AM, Adam Goler wrote:
> Hello,
> 
> Does the PX3 panadapter work for the KX2?
> 
> Does anyone with a KX2 have a different panadapter-esque solution?
> 
> I have a 7” android tablet that I was hoping to use as a waterfall 
> display/mobile computer for portable ops. But I could just as easily 
> substitute a small laptop or raspberry pi if necessary.
> 
> Open to any suggestions!
> 
> Thanks and 73
> 
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html


---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus