[Elecraft] K4 Remote Control

[dgb]

Will a K3 be able to talk to the K4 remotely?

I currently use two K3's and sometimes a k3 mini and have been for 6 years.

As was mentioned two K4's will be cost prohibitive for me..

73 Dwight NS9I

On 5/21/2019 8:55 AM, Wayne Burdick wrote:
> This is definitely supported by the K4 and would be a preferred way to handle networking delays.
>
> Wayne
> N6KR
>
>
>> On May 21, 2019, at 6:33 AM, Andy Durbin <a.durbin at msn.com> wrote:
>>
>> "3) CW performance can be improved over RemoteRig.  Instead of sending "dit
>> and dah" elements, consider sending ASCII characters or a variant where full
>> characters are transmitted in a data packet."
>>
>>
>> If K4 uses a super-set of K3 commands then I assume it would support KY mode ( ASCII characters transmitted over the CAT interface) for CW.     I think this mode would be a lot better known if it was supported by N1MM+ but, last time I checked, it isn't.
>>
>> 73,
>> Andy, k3wyc
>>
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>>
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>
>