[Elecraft] K4 Remote Control

[Wayne Burdick]

This is definitely supported by the K4 and would be a preferred way to handle networking delays.

Wayne
N6KR


> On May 21, 2019, at 6:33 AM, Andy Durbin <a.durbin at msn.com> wrote:
> 
> "3) CW performance can be improved over RemoteRig.  Instead of sending "dit
> and dah" elements, consider sending ASCII characters or a variant where full
> characters are transmitted in a data packet."
> 
> 
> If K4 uses a super-set of K3 commands then I assume it would support KY mode ( ASCII characters transmitted over the CAT interface) for CW.     I think this mode would be a lot better known if it was supported by N1MM+ but, last time I checked, it isn't.
> 
> 73,
> Andy, k3wyc
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html