[Elecraft] Settings for Digital use

[Joe Subich, W4TV]

Are you using DATA A for most daata modes and AFSK A for RTTY?

Have you made sure there is *nothing* connected to the Line In jack?

Have you confirmed that MENU:MIC+LINE = OFF?

*AFTER* selecting DATA A/FSK A have you set MENU:MIC SEL = Line In?

*AFTER* selecting DATA A/AFSK A have you adjusted the mic gain for
*FOUR BARS* of ALC?  The Mic Gain control is "overloaded."  The
Line In defaults to *0* and can not be adjusted until you have
selected DATA A/AFSK A.

Finally, in AFSK A if CONFIG:AFSK TX = FIL ON, make sure that the
MARK frequency in MMTTY is the same as PITCH and do not tune by
"clicking in the waterfall".

73,

    ... Joe, W4TV


On 2019-03-12 11:23 AM, JAY wrote:
> I have the KI03BU installed.No problem RX but unable to TX. I know there
> has to be some settings I am missing.
> This was installed at Elecraft.
> 
>