[Elecraft] Settings for Digital use

[Don Wilhelm]

Jay,

Do you have the soundcard (AUDIO CODEC) properly defined as the 
soundcard in your application software?  That is the 1st step to check.

Secondly, are you driving the soundcard output audio to a sufficient 
level to illuminate 4 bars solid on the ALC meter with the 5th bar 
flashing?  Depending on what digital modes you are using, you may have 
up to 3 controls for the transmit audio level.

Take a look at my website www.w3fpr.com article on this subject.  Scroll 
to the last article in the left column and click to view the document.
Ignore the common internet advice - Elecraft transceivers control power 
differently than other amateur transceivers.

73,
Don W3FPR

On 3/12/2019 11:23 AM, JAY wrote:
> I have the KI03BU installed.No problem RX but unable to TX. I know there
> has to be some settings I am missing.
> This was installed at Elecraft.
> 
>