[Elecraft] KPA-1500 gone berserk

[N4ZR]

I just got done replacing the LPF board in my amp (SN 502) and 
everything seemed fine for a little while.  Now, suddenly, every time I 
try to run the amp in OPER mode, it faults with either Fault 6 (on the 
K3's LCD) , FAULT: PWR INPUT 67-68  WATTS (varies), or FAULT: PWR HI FOR 
SWR BYPASS 1.0.  This with my known good dummy load on Ant 2 selected 
and running as little as 10 watts input to the K3.

I will get with Elecraft support on Monday, but right now I was 
wondering if perhaps this is operator error of some kind that might be 
easily remediable, hence this message.

-- 

73, Pete N4ZR
Check out the Reverse Beacon Network
at <http://reversebeacon.net>, now
spotting RTTY activity worldwide.
For spots, please use your favorite
"retail" DX cluster.