[Elecraft] P3 Not Zeroed

[Kevin, N4TT]

Only to read the scale. Keyed from the rig.

It's working guys! As I mentioned, everything is lining up as expected.

This is why I went with Elecraft. Because of this group. Last group would
have been everything from RTFM to why would you want to do that...

73,
Kev N4TT

On Thu, Jul 25, 2019 at 8:56 PM Don Wilhelm <donwilh at embarqmail.com> wrote:

> Kev,
>
> Do you have FlDigi set to produce audio tones in SSB mode for CW or is
> it keying the K3 directly?
> That will make a significant difference, and the P3 signal placement
> will reflect that.
>
> We did not consider that you were using a software application to
> produce CW previously to this post.
> Know what your software application is doing and you may have the answer
> to your question.
>
> 73,
> Don W3FPR
>
> On 7/25/2019 2:41 PM, Kevin, N4TT wrote:
> > Hi Don:
> >
> > I'm still checking things out but I think I have it all working
> > together. I calibrated the radio using WWV at 5, 10 and 15 MHz. I only
> > had to line up one and the other two fell right in. Then I went to the
> > P3 and lined that up with ref cal. Again, everything lined up at 5, 10
> > and 15.
> >
> > Then I want back to fldigi which is where I originally noticed the
> > difference. I have the radio and fldigi set for a CW sidetone of 600
> > Hz. When I would tune in the radio for the 600 Hz tone on a random CW
> > signal, the peak of the P3 trace was right over the signal and Fldigi
> > showed the signal up at  600 Hz. Everything matched. This is what I
> > was looking for, the three functions matching.
> >
> > I think I'm in good shape.
> >
> >
>
>