[Elecraft] P3 Not Zeroed

[Don Wilhelm]

Kev,

Do you have FlDigi set to produce audio tones in SSB mode for CW or is 
it keying the K3 directly?
That will make a significant difference, and the P3 signal placement 
will reflect that.

We did not consider that you were using a software application to 
produce CW previously to this post.
Know what your software application is doing and you may have the answer 
to your question.

73,
Don W3FPR

On 7/25/2019 2:41 PM, Kevin, N4TT wrote:
> Hi Don:
>
> I'm still checking things out but I think I have it all working 
> together. I calibrated the radio using WWV at 5, 10 and 15 MHz. I only 
> had to line up one and the other two fell right in. Then I went to the 
> P3 and lined that up with ref cal. Again, everything lined up at 5, 10 
> and 15.
>
> Then I want back to fldigi which is where I originally noticed the 
> difference. I have the radio and fldigi set for a CW sidetone of 600 
> Hz. When I would tune in the radio for the 600 Hz tone on a random CW 
> signal, the peak of the P3 trace was right over the signal and Fldigi 
> showed the signal up at  600 Hz. Everything matched. This is what I 
> was looking for, the three functions matching.
>
> I think I'm in good shape.
>
>