[Elecraft] K3S AGC action in CW

[Roger]

That was the first thing I did (including reading and rereading the manual) however changing the settings didn´t affect the AGC action in CW. The AGC settings are identical in all modes (default) therefore I would expect identical behavior in all modes. And in fact it does EXCEPT for CW. No matter whether AGC is set to fast or slow in CW it stays slow. 

73/Roger - DL5RBW

-----Original Message-----
From: Ken K3IU [mailto:kenk3iu at cox.net] 
Sent: Friday, July 19, 2019 12:34 PM
To: Roger; elecraft at mailman.qth.net
Subject: Re: [Elecraft] K3S AGC action in CW

There are numerous AGC adjustments available in the CONFIG menu. You can probably find something to suit you there.
73, Ken K3IU
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

On 7/19/2019 4:14 AM, Roger wrote:
> Hi,
>
> when operating the K3S in CW mode I found there is no difference in 
> switching between AGC-F(ast) and AGC-S(slow). It seems the "default" 
> setting is on slow and does not go to fast (compared to the decay 
> characteristic in SSB).
> The manual explains that the AGC Fast/Slow response should also be 
> effective in CW.
>
> Can anyone confirm this behavior (or not)?
>
> Firmware version is 5.66 (actually supposed to be 5.67 with the 
> "label" of the previous version).
>
> 73/Roger - DL5RBW
>
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net Please help support this email 
> list: http://www.qsl.net/donate.html Message delivered to 
> kenk3iu at cox.net
>