[Elecraft] K3s & P3 used with Data

[Jim Brown]

It does NOT, and DATA A (USB) MUST be used, NOT in REV mode. Among other 
things, WSJT modes won't decode if the signal is reversed.  Detailed 
instructions from ARRL for data modes on 60M are at the link below.  FT8 
operation should do the same as described for PSK31 -- set the TX 
frequency for 1500Hz.

http://www.arrl.org/60m-channel-allocation

I don't work 60M, but it's my understanding that frequency allocations 
on this band vary from one country to another, so it may be necessary to 
work split.

73, Jim K9YC

On 1/31/2019 3:29 PM, Bob wrote:
> No matter what the scope says, I don't understand why it has to be put into
> DATA REV in order to decode signals obviously sent as USB.