[Elecraft] ERR TXF

[Mpridesti]

Thanks Vic 

Guess I need to spend some quality time in the filter configuration portion of the manual.  Did manage to get the BW set so I use CW again but need to really setup the filters by BW.  

Thanks all!

Regards,
Mark, K1RX 


> On Jan 10, 2019, at 3:50 PM, Vic Rosenthal <k2vco.vic at gmail.com> wrote:
> 
> Select AM mode and then go to CONFIG:FLTX.
> Or (better) use the he configuration tab of the K3 utility, as Don suggested.
> 
> Victor 4X6GP 
> 
>> On 10 Jan 2019, at 21:04, Mpridesti <mpridesti at yahoo.com> wrote:
>> 
>> Ok understand except how do you select AM and have it stay?
>> 
>> Went to the CONFIG menu and selected FLTX (it shows CW in al FL numbers)  Tried to select a different mode I.e. AM but it does not stay AM
>> 
>> Regards,
>> Mark, K1RX 
>> 
>> 
>>> On Jan 10, 2019, at 1:49 PM, Victor Rosenthal 4X6GP <k2vco.vic at gmail.com> wrote:
>>> 
>>> This error is caused by selecting a filter other than the 2.8 or 2.7 kHz filter as the transmit filter. Use CONFIG:FLTX to select that filter for CW/DATA/SSB. (Except if you have FM (13 kHz) or AM filters (6 kHz) you must select those filters in the FM and AM modes).
>>> 
>>> 73,
>>> Victor, 4X6GP
>>> Rehovot, Israel
>>> Formerly K2VCO
>>> CWops no. 5
>>> http://www.qsl.net/k2vco/
>>>> On 10 Jan 2019 20:08, Mpridesti via Elecraft wrote:
>>>> Strange issue
>>>> I setup the K3 for diversity RX
>>>> Now I can not transmit CW. I get an ERR TXF
>>>> indication. What needs to be changed to correct?
>>>> Regards,
>>>> Mark Pride
>>>> 603-231-8965
>>