[Elecraft] ERR TXF

[Vic Rosenthal]

Select AM mode and then go to CONFIG:FLTX.
Or (better) use the he configuration tab of the K3 utility, as Don suggested.

Victor 4X6GP 

> On 10 Jan 2019, at 21:04, Mpridesti <mpridesti at yahoo.com> wrote:
> 
> Ok understand except how do you select AM and have it stay?
> 
> Went to the CONFIG menu and selected FLTX (it shows CW in al FL numbers)  Tried to select a different mode I.e. AM but it does not stay AM
> 
> Regards,
> Mark, K1RX 
> 
> 
>> On Jan 10, 2019, at 1:49 PM, Victor Rosenthal 4X6GP <k2vco.vic at gmail.com> wrote:
>> 
>> This error is caused by selecting a filter other than the 2.8 or 2.7 kHz filter as the transmit filter. Use CONFIG:FLTX to select that filter for CW/DATA/SSB. (Except if you have FM (13 kHz) or AM filters (6 kHz) you must select those filters in the FM and AM modes).
>> 
>> 73,
>> Victor, 4X6GP
>> Rehovot, Israel
>> Formerly K2VCO
>> CWops no. 5
>> http://www.qsl.net/k2vco/
>>> On 10 Jan 2019 20:08, Mpridesti via Elecraft wrote:
>>> Strange issue
>>> I setup the K3 for diversity RX
>>> Now I can not transmit CW. I get an ERR TXF
>>> indication. What needs to be changed to correct?
>>> Regards,
>>> Mark Pride
>>> 603-231-8965
>