[Elecraft] K2 Front Panel Resistance Check Readings :(

[Don Wilhelm]

If the reading is actually zero - like when the leads are touched to 
each other, then that is zero ohms, an indication of a short.
OTOH, if the reading is blank or whatever your ohmmeter reads when the 
leads are attached to nothing, then that is an indication of infinite 
resistance or something very high - and that qualifies as greater then 
(> symbol) 100k ohms.

73,
Don W3FPR

On 8/18/2019 6:53 PM, W0CD wrote:
> Don,
> 
> Thanks. I see quite a few others on this board have had the same problems in
> the past. I'm wondering if my multimeter is reading 0 ohms due to infinite
> resistance. I'll take a look at my soldering and see what I find. I didn't
> notice much during my previous look last night.
> 
> For reference:
> 
> http://elecraft.365791.n2.nabble.com/K2-4670-Front-Panel-Resistance-Checks-td374437.html
> 
> (You replied to this one in 2006)
> http://elecraft.365791.n2.nabble.com/K2-Front-Panel-Board-Resistance-checks-td386855.html
> 
> http://elecraft.365791.n2.nabble.com/Resistance-Checks-During-Front-Panel-Assembly-td392133.html#a392141
> 
> Thanks again.
> 
> 
> 
> --
> Sent from: http://elecraft.365791.n2.nabble.com/
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to donwilh at embarqmail.com
>