[Elecraft] No Tx Audio

[Joe Subich, W4TV]

 >  Not sure if this is a K3 issue or a Windows 10 problem.

Turn on the K3 Monitor (turn up the level).  Select a Data
mode, *HOLD* the CMP/PWR/MONI encoder in until the VFO B
area of the display shows MONI ## and adjust ## until you
hear the monitor audio while transmitting.

All documented in the Owners Manual ...

73,

    ... Joe, W4TV


On 2018-10-17 2:46 PM, paul ecker via Elecraft wrote:
> Problem: Not hearing any audio during transmit in digital modes.I have a K3, Win 10 PC, with microHam DKII interface. When transmitting inRTTY, PSK31 or FT-8 I am not hearing any Tx audio, which I had been previously.  I first noticed this in RTTY when not hearingany diddles. But when using MMTTY – the K3 goes to Tx , I am getting power out and Iam being seen on the RTTY RBN. In PSK31 using WinWabler and FT-8 using WSJT-X, Iam making successful QSO’s. I have gone thru the DK II manual setup pages for theseprograms and cannot find errors in my setup. Not sure if this is a K3 issue or a Windows 10 problem. Anyone have any ideas on what might be wrong?
> 73Paulw2eck
>   
>