[Elecraft] CODEC

[ROBERT MUELLER]

Mike, I would be interested in what you find.  Since Microsoft and then HRD did upgrades I have not been able to get WSJT to work with HRD and my K3S, therefore, the logging from FT* to HRD will not work.  When I try to set things up I get a message:   Hamlib error: IO error while opening connection to rig.  I am running a USB cable which worked fine until all the upgrades.  Very interested in what you find.
Bob, k8rgm at comcast.net
> On October 1, 2018 at 11:49 AM Mike Greenway <K4PI at BELLSOUTH.NET> wrote:
> 
> 
> I have used for years a K3 on EME with WSJT using Line In/Out audio.  Recently got a K3S and I am now using USB (CODEC) audio in and out of the radio.  In WSJT-10 they have Rate In/Rate Out monitors that should normally run at 1.000. Using the K3 analog audio these always stayed right on 1.000 but now that I am using the USB audio they are jumping around quite often and getting out of range indicated in WSJT with a red marker.  I have tried two different computers and the same result.  I tried changing the sample rate in the computer audio settings but no change in the problem.  I plan to go back to analog Line In/Out on the K3S unless someone has an idea on how to settle down the Rate In/Out fluctuations.  I have not found anything in the K3S that might affect this.  You can reply off line if you like.  73 Mike K4PI
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to k8rgm at comcast.net