[Elecraft] KPA1500

[Walter Underwood]

On page 44, the manual suggests this for a 12V fault:

   Verify the DA-15 Control Cable is firmly installed on both Power Supply and RF Deck.

   Tighten thumbscrews fully.

wunder
K6WRU
Walter Underwood
CM87wj
http://observer.wunderwood.org/ (my blog)

> On Nov 28, 2018, at 3:07 PM, Larry <wa9mag at ameritech.net> wrote:
> 
> My KPA1500 faults on all bands and goes offline.  The reset button quickly gets it back up only to fault again.  The error message is:
> 
> 		Fault: 12V supply
> 		10.8 volts
> 
> The line voltage is stable with a pair of #10’s going to the breaker box.
> 
> Anybody got any ideas before I call support?
> 
> Larry, WA9MAG
> 
> 
> Sent from Mail for Windows 10
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to wunder at wunderwood.org