[Elecraft] K3S and N1MM+ on cw with no interface

[Jim Cary]

I have the  USB connected and am reading the frequency fine.  
> On Nov 22, 2018, at 2:12 PM, Nr4c <nr4c at widomaker.com> wrote:
> 
> You need some sort of connection between the radio and computer. Simplest is the USB cable that came with your K3S. Set CONFIG/PTT/KEY to RTS DTR on the radio of in n1mm+ go to Configure and set the com port (from Win device manager “ports”) and set the radio and then set KEY  and PTT same as you did the radio. 
> 
> Sent from my iPhone
> ...nr4c. bill
> 
> 
>> On Nov 22, 2018, at 11:46 AM, Jim Cary <jimlcary at gmail.com> wrote:
>> 
>> I’m trying to get my K3S and N1MM+ to work on cw without an interface (which I have used in the past).  I’ve tried a couple of the suggestions I’ve seen on  the reflector but none of them seem to work.
>> 
>> I’m sure someone has figured out an easy way to do this and would appreciate the info.
>> 
>> Thanks,
>> 
>> Jim
>> W2SM
>> 
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>> 
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>> Message delivered to nr4c at widomaker.com
>