[Elecraft] WSJT-X Disabling TX INHIBIT on K3S

[Jack Brindle]

Andy;

Are you saying that you have to send the radio a serial command to engage and disengage the inhibit property? I don’t see how that is really useful for SO2R where you need pretty much instant switching, but then I doubt that is its use on the Kenwood.
That leads to the question of how the TS590S is protected in an SO2R or similar multi-tx environment.

73!
Jack, W6FB

> On Nov 13, 2018, at 6:33 PM, ANDY DURBIN <a.durbin at msn.com> wrote:
> 
> "How does one implement TX Inhibit on a Kenwood TS-590?"
> 
> 
> On a TS-590S TX inhibit is menu 60. The EX command is used to change menu settings over CAT. For a TS-590S -
> 
> 
> EX06000000; reads the inhibit status
> 
> EX060000001; sets TX inhibit
> 
> EX060000000; clears TX inhibit
> 
> 
> For a TS-590SG the menu number is 66 so substitute 060 with 066 in the commands above.
> 
> 
> Note that, like almost all menu selections, the inhibit will only apply to the menu (A or B) in which it was set. To be safe it should be applied to both menus.
> 
> 
> Andy k3wyc
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to jackbrindle at me.com