[Elecraft] WSJT-X Disabling TX INHIBIT on K3S

[Joe Subich, W4TV]

Without an eternal control line (inhibit), the Kenwood TX Inhibit
is more like the Elecraft Test Mode (allows operation but no RF
output).  I'm looking for that external control.

73,

    ... Joe, W4TV


On 2018-11-13 9:33 PM, ANDY DURBIN wrote:
> "How does one implement TX Inhibit on a Kenwood TS-590?"
> 
> 
> On a TS-590S TX inhibit is menu 60. The EX command is used to change menu settings over CAT. For a TS-590S -
> 
> 
> EX06000000; reads the inhibit status
> 
> EX060000001; sets TX inhibit
> 
> EX060000000; clears TX inhibit
> 
> 
> For a TS-590SG the menu number is 66 so substitute 060 with 066 in the commands above.
> 
> 
> Note that, like almost all menu selections, the inhibit will only apply to the menu (A or B) in which it was set. To be safe it should be applied to both menus.
> 
> 
> Andy k3wyc
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to lists at subich.com
>