[Elecraft] K3 - TX EQ settings not remembered.

[Gary Smith]

Don,

I'll give your suggestion a try & see how 
that does.

I do use Win4K3, I need it to use WSJT as 
WSJT doesn't like to share ports. I used 
to use LP-Bridge which let me 
simultaneously run all my software 
flawlessly, till WSJT... and I fast 
discovered it would not play nice unless 
WSJT had sole communication with my 
K3/K3s. 

With Win4K3 I can use all the software 
simultaneously including WSJT, logging 
program, N1MM & MMTTY without having to 
shut all the other software down every 
time I want to change modes or software.

If it wasn't for WSJT making this issue, 
it would be simple to just keep doing what 
I was doing with LP-Bridge. As I do use 
MSK144 & some FT8 and want to keep my 
logging program running, I need to keep 
using Win4K3.

Tom wrote a clever bit of software, 
perhaps there is a way to tell it not to 
change EQ settings, I'll have to check 
that too.

Thanks & 73,

Gary
KA1J





> Gary,
> 
> Are you using any software to control the K3?
> I have just been informed that Win4K3 will often change the EQ
> settings.
> 
> Remove the USB or RS-232 connection and try it with only the K3, then
> set the SSB TX EQ.  Check later to see if it has changed.
> 
> 73,
> Don W3FPR
> 
> On 11/2/2018 3:29 PM, Gary Smith wrote:
> > Hi Don,
> > 
> > No, I set them for SSB and at a later time
> > the TX EQ is flat and I have to change it
> > back to the settings to fit my mic. I
> > don't use AM except to listen to broadcast
> > stations & listen to the nature of RFI.
> > 
>