[Elecraft] K3 - TX EQ settings not remembered.

[Gary Smith]

I seem to have an issue with the K3 memory 
settings for the microphone. I changed the 
TX EQ to match settings and now when I 
check, the TX EQ is back to flat again. 
This has been happening since I set the 
values. I've had to restore the values I 
know them by heart and can do it quickly. 
Still, I don't know when they get lost so 
I always have to keep checking to be sure 
they are still active.

Just now, when I checked the different 
modes I find AM mic settings modified in 
the TX EQ but not with the same values as 
I used. I set the TX EQ for use with SSB 
and the MH4, I only found the AM settings 
were other than "0" when listening to some 
power line RFI on AM & that AM setting was 
still on when I happened to check the TX 
EQ settings. All the other mic settings 
for SSB were back to default 0.

Having had to reset the mic settings 
frequently, last night I made the 
settings, turned off the K3, restarted & 
the settings were still intact. This next 
day, they are now lost again.

To make the settings I enter the main 
config. Tap the needed # to get each 
individual audio band, I use VFO A to 
select the desired value, tap config when 
done to exit and that's all I do. What am 
I missing to save this to the K3's 
non-volatile memory?

Thanks & 73,

Gary
KA1J