[Elecraft] K3 - Amplifier Recognition

[Bill Stravinsky]

 I'm thinking there will be a firmware update to fix this.  I don't have a Y box but the only menu choice in the K3 is kpa500 and that is what I see from the 1500on the K3 display although it might already be fixed as I haven't upgraded firmware in a while.
BillK3WJV

    On Sunday, May 27, 2018, 8:08:40 AM EDT, Bill via Elecraft <elecraft at mailman.qth.net> wrote:  
 
 Using N6TV ‘s “Y-Box,” I can switch between the KPA500 or my new KPA1500 effortlessly as needed. However, regardless of which amp is active, the K3 message that informs you that the amp has been switched to/from stand-by to active always reads KPA500. 
For someone running amps in the same configuration remotely, this maybe an issue. 
Has anyone else noticed this? 
If so, have you determined a remedy?

Thanks, 
Bill-W0BBI


______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to k3wjv at yahoo.com