[Elecraft] K2 Build: Options Advice

[David Woolley]

The disadvantage is that you will need to unsolder some components.  In 
most cases, I think you can destroy the through holes, but there is at 
least one case where you have to insert a new value in the old hole.

There used to be a, third party, product, called UnPCBs, which provide a 
minimal dummy version of most of the modules, but the sales of the K2 
dropped to a level where it wasn't worth another production run for the 
PCBs for this.

-- 
David Woolley
Owner K2 06123


On 24/05/18 19:44, AE0MM wrote:
> I'm planning to build a K2/10 with the following options:
> KNB2
> KAT2
> KAF2
> 
> Is there any disadvantage to building the base K2, then adding the options later?