[Elecraft] P3: How to Get Frequency on top center of P3

[Don Wilhelm]

Mark,

Are you using the USB cable to connect the K3S to the computer?  If so, 
do you have the CBLP3Y cable connected between the K3S RJ-45 jack and 
the P3 RS-232 connectors?  If you do have that cable, make certain the 
RJ-45 plug is fully inserted.  You may have to pull back the cover and 
push the metal part of the plug in completely - it must snap in.

If you do not have the CBLP3Y cable, you can use the RJ-45 to RS-232 
cable that comes with the K3S to connect to the P3, but you must set the 
K3S menu to RS-232 rather than USB (use 38400 baud).  Connect to the PC 
from the RS-232 connector on the P3.

73,
Don W3FPR

On 5/22/2018 5:35 PM, Mark Wheeler wrote:
> I am using the P3 with a K3S and cannot figure out how to get the VFO A frequency to appear at the top center of the P3. (My P3 is showing a “0” at the top center.)