[Elecraft] K3Audio

[Bob McGraw K4TAX]

I certainly agree with Joe on this point.   I hear many voice / 
background noise signals in the "CW" portions of the bands. Furthermore, 
fact is, it isn't legal to transmit such.

  suppose if one wishes to run Slow Scan TV with audio in the SSB 
portion of the band it might be justified.  Otherwise, I still say it is 
a terrible idea.

73

Bob, K4TAX




On 3/31/2018 11:21 AM, elecraft-request at mailman.qth.net wrote:
> Message: 20
> Date: Fri, 30 Mar 2018 17:02:30 -0400
> From: "Joe Subich, W4TV"<lists at subich.com>
> To:elecraft at mailman.qth.net
> Subject: Re: [Elecraft] Re K3 Audio
> Message-ID:<8fefe1dd-41c4-8e7f-029e-5d41a29a4c50 at subich.com>
> Content-Type: text/plain; charset=utf-8; format=flowed
>
>
>   > I need both at the same time,  Mike for voice and Line in for digital.
>
> This is absolutely a terrible idea. I doubt that your shack is silent
> while working data modes and any noise - you talking, someone else
> yelling at your, a TV/radio/computer running in the background, or even
> fan noise will be picked up by the open mic.
>
> That said ...
>
>> Does any one know the command for both Mike in Front Panel and Line
>> in rear panel?
> Assuming you will be using USB*with CMP set to zero*, set MENU:MIC SEL
> as needed for your mic and MENU:MIC+LIN = ON.
>
> Note: you will first need to set MENU:MIC SEL=LINE and adjust the mic
> gain/sound card output for four to five bars of ALC.  This sets the Line
> IN gain.  Then switch to MENU:MIC SEL as needed for your mic (FP.h or
> FP.L) and again adjust the mic gain for ALC peaking between 5 to 7 bars.
> Now you can select MENU:MIC+LINE and set it to ON to enable both inputs.
> Adjusting the mic gain with MENU:MIC+LINE = ON will adjust*ONLY*  the
> mic gain for the*MICROPHONE*  input, in order to change the Line In
> (digital) level, you will need to adjust the sound card output*or*
> change MENU:MIC SEL to LINE before adjusting the mic gain.
>
> 73,
>
>      ... Joe, W4TV
>