[Elecraft] K3S TX Noise Gate

[GRANT YOUNGMAN]

It doesn’t have much to do with “audio knowledge”, it has to do with how these specific radios behave when you push EQ to high positive values.  No one is questioning Heil’s audio chops, but that doesn’t translate into him being a knowledgable expert on the Kx radios.  

This has been discussed here ad nausaum.  You’re better off, if you can, to scale values DOWN to get an EQ curve rather than push them up.


> On Mar 18, 2018, at 9:07 PM, Richard <FlatHat at comcast.net> wrote:
> 
> May I draw your attention to the bottom of this page.
> 
> https://heilsound.com/heil-amateur-radio/support/dsp-settings/all-things-elecraft/
> 
> But then, what does Bob Heil know about audio?
> 
> Richard - W4KBX
> 
>> On Mar 18, 2018, at 1:25 PM, Don Wilhelm <donwilh at embarqmail.com> wrote:
>> 
>> Richard,
>> 
>> Remove the boost on the high end.
>> You can reduce all bands if you want to maintain the same curve.
>> It is better not to boost, but cut instead.
>> 

Grant NQ5T
K3 #2091, KX3 #8342