[Elecraft] K3 and WSJT-X Split operation.

[Wes Stewart]

Do you have the same mode selected for both VFOs?  Give the A -> B a double tap 
to be sure. Understand that in Hound mode you need to set your TX frequency 
above 1000 Hz.  If the Fox calls you he will move your TX down to his frequency.

I'm still experiencing a TX delay, which I think is WSJT commanding the K3 to go 
Split and then waiting for confirmation. This has been discussed before.  Also, 
I use VOX and we still don't have VOX settings remembered by mode, so there is 
constant fiddling to get the VOX to activate.

Wes  N7WS


On 6/29/2018 9:46 AM, K1RI wrote:
> I too run split FT8 Data A.  I cannot get the K3 to transmit in the WSJT
> DXPedition Hound. What am I missing?  My IC-7610 works great and I would run
> a comparison.
>
>
> Tnx,  Bob K1RI
>