[Elecraft] KX3 - Strange Behaviour

[Kurt Pawlikowski]

Brian,

     We were in a high noise area and yes, I had the NB on. {'-) I 
suspect that was the "muffled" artifact I was getting, but the "ghost" 
signal, I'm not so sure about! {'-) All I know is that I'd call on one 
of them, and they'd usually answer. Sorry I didn't pay any closer 
attention to the spacing and such. Might be a clue for someone 
attempting to eliminate the issue!

     k WB9FMC


On 6/27/2018 10:40 AM, Brian Hunt wrote:
> Did you have the NB on?  I've noticed on my KX2 (similar h/w and firmware) that using the NB with very strong signals close by will create all sorts of artifacts like CW being sent using a highly damped bell. Turn off the NB and it's clean as a whistle. HTH
>
> 73,
> Brian. k0DTJ
>
>>     Our setup was in, unfortunately, a fairly high noise area. I was working 20 CW. The noise level was S3, with times reaching S6. I believe, "normal" would be closer to S1. And, of course, lots of signals all over the board signal strength wise. Many of them very strong (10 to 20 over 9!).
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to kurtt at pinrod.com
>