[Elecraft] KX3 - Strange Behaviour

[Brian Hunt]

Did you have the NB on?  I've noticed on my KX2 (similar h/w and firmware) that using the NB with very strong signals close by will create all sorts of artifacts like CW being sent using a highly damped bell. Turn off the NB and it's clean as a whistle. HTH

73,
Brian. k0DTJ

>    Our setup was in, unfortunately, a fairly high noise area. I was working 20 CW. The noise level was S3, with times reaching S6. I believe, "normal" would be closer to S1. And, of course, lots of signals all over the board signal strength wise. Many of them very strong (10 to 20 over 9!).