[Elecraft] Tx Mon

[Jack Brindle]

Also remember that each box you insert into the line will cause impedance bumps and thus each will see slightly different loads. Thus the forward and reflected power readings may not perfectly match. In some cases the variance (usually as seen in SWR) can be striking.

Jack, W6FB


> On Jun 21, 2018, at 6:14 AM, Don Wilhelm <donwilh at embarqmail.com> wrote:
> 
> Bob,
> 
> It does not matter - RF will flow through one and then the other.
> Depending on how much coax you have between them, you will see some difference in SWR unless the feedline is perfectly flat.
> 
> 73,
> Don W3FPR
> 
> On 6/21/2018 2:43 AM, Bob DeHaney wrote:
>> I have a P3 with the TX Mon option.  I have an LP100A sensor in my feedline.
>> Should the Tx Mon sensor be installed before or after the LP100A sensor, or
>> it doesn't matter?
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to jackbrindle at me.com