[Elecraft] K3 AF knob..

[Michael Eberle]

I just contacted them this week for a broken AF knob and they said they 
were sending a couple at no cost.

73,

Mike KI0HA


On 6/8/2018 08:14, Don Wilhelm wrote:
> Linas and all,
>
> I don't know if the policy is still in place, but several years ago, 
> Eric stated that defective knobs would be replaced at no cost.  
> Contact Elecraft support.
>
> 73,
> Don W3FPR
>
> On 6/8/2018 8:25 AM, Linas Balsys wrote:
>> The same is here. It is the crack in the knob, I can see it. You can 
>> try to
>> tighten up the screw a bit but not too much not to finaly break the 
>> knob.
>> If it is not completely loose you still can find the end stop while 
>> turning
>> very gently and slowly. The best way surely is to get the knob 
>> replaced :)
>> 73 Linas LY2H
>>
>>
>> <<It's taken me 8 years to finally "break" something. Well it's 
>> not....>>
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>>
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>> Message delivered to donwilh at embarqmail.com
>>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to mteberle at mchsi.com
>