[Elecraft] RF Meter Doesn’t Move when radio set to 10 watts

Bob McGraw K4TAX rmcgraw at blomand.net
Wed Jul 11 19:26:21 EDT 2018


Mine shows the power output regardless of the PWR setting.  It shows a 
10 watt full scale range when it is set to 10 watts PWR or less.  If I 
set the PWR to 20 watts the meter switches to 100 watts full scale and 
indicates accordingly.    My default TUNE power setting is 25 watts and 
the meter shows 25 watts on a 100 watt scale.    The transition PWR 
point is 12 watts, thus when PWR is greater than 12 watts the 100 watt 
scale + 2 bars is displayed and when the PWR is less than 12 watts the 
10 watt scale is displayed + 2 bars.  The actual output follows accordingly.

73

Bob, K4TAX



On 7/11/2018 4:59 PM, tomb18 wrote:
> HiDo you have the 100w amp in the k3? Is it enabled in the menus? The meter reading switches at 10w so perhaps this is related? 73 Tom va2fsq.com
>
>
> Sent from my Samsung Galaxy smartphone.
> -------- Original message --------From: usmcss <perry at spotlightdisplays.com> Date: 2018-07-11  3:59 PM  (GMT-05:00) To: elecraft at mailman.qth.net Subject: [Elecraft] RF Meter Doesn’t Move when radio set to 10 watts
> Been trying to figure out why every once in a while “Ext. Mic” will display
> on the screen when transmitting. I’m working with Elecraft on it currently.
>
> My question is; does anyone notice when you have the radio set to 10 Watts
> the RF meter only shows on bar? When I set the radio below 9.8 watts the
> meter always works fine.
>
> I can adjust the mic gain up and down while set at 10 watts and the RF meter
> will start moving again. Even when I put it back on the mic gain setting
> that it wasn’t working on. But when I turn the radio off and back on the RF
> meter doesn’t move unless I’m under 9.8 Watts?
>
> Even if I get the RF meter to start moving again when I adjust the mic
> control, if I wait a little while it will stop moving. It does it with the
> internal mic as well.
>
> And just to be clear, this is happening when I push PTT and talk into mic.
>
> Anyone have any idea on this? If you could check your radio I would
> appreciate it.
>
> Thank you!!!
>
>
>
> --
> Sent from: http://elecraft.365791.n2.nabble.com/
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to tomb18 at videotron.ca
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to rmcgraw at blomand.net




More information about the Elecraft mailing list